![]() ![]() (Note that a damaged wire or a repair using this method, unless done well, may present an electric shock or fire hazard. Removing this is not as difficult as it sounds, although each bulb you remove will cause the remaining bulbs to burn more brightly and therefore burn out sooner though removing one or two bulbs should be fine. If a new bulb still won't light up, your socket may be corroded or the wire may be damaged nearby. Mark this bulb with tape so you don't lose track, then replace this bulb as described below. Repeat until you find a bulb with current on one side of it and no current on the other.Move the tool to the middle of the problem area and test again, narrowing it down to ΒΌ of the string. ![]() If there is no hum or light, the problem is in the half closest to the plug. If the tool hums or lights up (depending on model), the problem is in the half of the string farthest from the plug.(If your tool has a small hole for a detector, place a light bulb into the hole instead. Place the detector on this wire about halfway along the string, between two bulbs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |